Quote:
Originally Posted by cdlong
I had problems getting the 50 inch deck on my 1450 to raise level. After changing hanger assemblies and not getting deck level, I found 3 left side hangers that go between the lift arm and hanger assembly. All 3 are diffeent lehgths and the slots in them are different lengths. Check the roll pins in the lift shaft. I had one broken last year and that wouldn't let the deck raise level either.
|
It lifts even, just not very high. I switched rear hangers to the adj type on both side, they were slightly shorter than the solid hangers. They would be an inch shorter if they would adj, but are locked at the time, getting steady dose of PB in hopes of freeing up. I am going to assemble on the floor along with the 44C and carrier to check for differences. I feel like I need a different carrier, either the outer frame or the inner lift frame. I am betting something is slightly different and the one I have might be for a Quiet line or something instead of a 1x9 series. Any more ideas? I will get some pics this week and show more of what I am saying.