149 K321 block issue
I got to looking at the K321 from the 149 I was going to restore. After pulling the pan I saw that the connecting rod had broken close to the crank. I pushed the piston up and saw that the cylinder sleeve was broken off on one side right flush to the block. Guessing the block is done. Could be unseen damage as well. The piston was was marked 10 over. The connecting rod appeared STD. I did some searching today on rod breaks and saw this kind of damage. When I got home sure enough this one suffered the same.
Project will have to sit now till I figure if and how to proceed.
Craig
__________________
'67 125
'72 149
'61 IH Cub LoBoy
|