Quote:
Originally Posted by West Valley G
Looks like that bearing has issues for sure. Since you have it apart,
new bearing, new oil seal, and new O rings. There are 3.
Not sure where to go with it not staying in gear. Is there any obvious
wear in planetary gears? Perhaps the pin that holds the lever for the
shifter, the inside one, was set wrong.
Ken
|
The gears, in my opinion, look fine. Ill post pictures when I get off work. As for the pin, are you referring to the roll pin that goes in the yoke? It looked a little wore, but thats all I can tell from it.