With apologies for necroing an old post...
Herniated a disc in my spine earlier this summer, so never got around to implementing the advice in this thread. Feeling better now though, so I should be able to get after it with some help from a friend!
Ordered the spline coupler, got that in the mail yesterday. What shaft would I need to buy to replace that? Stands to reason if the coupler is getting replaced so is the actual shaft it's on. Or could a machine shop spray-weld and re-lathe it down to spec again?
And what has to come apart on the back end of the blower? Or is it all accessible from the front end once I get the augers out?
Thanks!
|