K301 in a CC123 question
Been working on the K301 in my CC123 and got to looking at the wire that goes from the coil on the - side to the points, it looks like it has been replaced at some point before I got it.
It looks like it is a 10 ga. wire and I would like to know if that is the right size or not. I may replace it just because I have the time and I don't like the way it is looking (not nice and neat), But if I 'am going to play around and clean it up I want to do it right as far as the wire size goes.
Thanks for the help,
Joe
|