[yingpin]

My 124 has been sitting in the garage in various stages of repair stemming from a shattered throw-out bearing. I ended up sourcing that bearing last year and with the kids sports schedule I have done very little. I ended up pulling the motor completely out of the tractor to try and get at these damn roll pins and after a long while of messing with them, I managed to get the second one out today.

So I pull what's left of the bearing off and it looks like the shaft is tapered. My understanding is that these are straight shafts so it has worn that way and now I need to replace the entire shaft. No idea how I am going to get the roll pin out of the back considering how hard the fronts were.

I need to source the following parts;
1- Drive Shaft (tapered after the left "rear" pin hole as shown)
2- Teaser Spring - Split in two
3- New roll pins? Can these be reused?