Quote:
Originally Posted by finsruskw
Abuse and neglect come to mind here although the coupler slot portion of the rear plate looks good, much better than many I have seen.
That gap looks closer to .100 from here.
|
Gap measured .140.
Clutch assembly was in a IH Cub Cadet 73 with a stock engine.
Quote:
|
What's the ID of the hubs on the plates and the rear coupler?
|
ID of plates was .630.
Coupler ID .638 -.631
Quote:
|
What's the OD of the shaft in those areas of wear, front and rear?
|
Drive shaft OD trans end was .610.
Pilot bushing end that goes into 3 pin driver .610
Quote:
|
Was the disc itself an OEM style w/the metal center plate?
|
OEM style with a metal plate