i need someone to correct me if im wrong, but i think i k341 and the k241 are similar blocks. i think you would have to change the flywheel, shroud, charging system, and the bearing plate from the k241 would have to go on the k341. you would also need the oil pan from the k241 and install it on the k341. the 100 is a narrow frame and uses the smaller flywheel. the 147, like the machine i have in my garage(my own project tractor) is the only one that used the large flywheel. the 147 is a moddified narrow frame and is the only narrow frame that was modified to fit the larger flywheel.
the only concern i would have is the small flywheel adaquate to cool the larger 16hp engine? im not sure about that.
as far as fitting, i think everything would fit just fine, so long as you changed to the small flywheel, shroud, and flywheel screen, cub charging/starting system, and oil pan(i think the deere's are different).
dont qoute me on this, im fairly certain that information i have provided is correct, im just not positive about it.
|