[Wntsom4]

So I’ve been deep into getting my tractor back up and running.

Been sitting 10 years.

Made the decision to buy a cheap carb off eBay to try yo get it started.

Cranked but found no spark.

Checked all the systems everting showing good
and 12volts found throughout. Took the starter off cleaned posts and grounds. Took of starter solenoid cleaned post and ground, coil removed cleaned post and grounded to head.

New plug,new points and gapped, new condenser put on today… we have spark!!

Still no start. Figured my cheap carb is now my issue. It won’t even pop. Just cracking over only.

Found by searching everything points to a #26 carb is the one that’s recommended.

Mine on the other hand is a Walbro 62-129 that I took off.

Being I have no clue the difference I’m asking here. I read here a lot of problems with them but I’m Looking to see if any other areas to look for or should I go to a more trusted vendor and order a #26??