Pulling the steering wheel would be fruitless even if you did get it off.
Only need to remove that is if you are going to rebuild the sector.
Remove the battery to access the solenoid.
1st off, make sure the terminals of everything electrical inclkuding grounds are clean, bright and tight.
.
You should have juice to the small wire on the solenoid with the key in the start position. This makes contact inside the unit completing the circuit to the starter proper.
Make sure the clutch is properly adjusted for smooth operation.
Sounds like you would be much better off having bought a later model hydro unit with a bigger deck for that much area. 3 acres is over 3/4 of a city block!
I sure would not like even thinking about mowing that much area with a gear drive Cub.
Please use some punctuation in your posts, they are a real PITA to read!
Good luck
|