Quote:
Originally Posted by Mike McKown
I'd be looking at the clutch area again.
|
Well I finally looked into this mess. Not sure if the joint at the creeper should wobble or not? This one does about 1/4" of play in a circular motion. pic#1
Clutch disks seem ok all three holes are round and Not egg shaped pic #2
I did notice that the throwout bearing appears to have been rubbing the realease lever, and wore a deep groove in it? Also when I removed the clutch assembly the shoulder bolt that holds the realease lever was missing the nut, and the lever had side to side movement until I put slight pressure on the pedal.
__________________
IH cub cadets 800x3,1000,1100,1200x2,1250DS,1450,1650DS, 71,122x2,123, 73x2,106,107,126x3,127,147x2,86x3,128,149, 169x2 ,Original, cadet 55, to name a few
CCC machines
1282,1050,2072,1535,1440
|