Quote:
Originally Posted by athomas
Yes that should be the correct installation, don't push the seals in to far as to block the drain hole as mentioned in an earlier post keep them out towards the pulley end of the fit. Here is the redi sleeve part you'd likely use but if the shaft is not pitted or undersized the redi sleeve should not be needed, is there a bushing/bearing worn that is causing excess play ? CR Seals (SKF) 99050
Thin Wall Speedi-Sleeve - 0.500 in Shaft Dia., 0.250 in Width, Stainless Steel Material
|
The only bushing there is inside is the idler gear.