Cub 1864 PTO light
Good evening! First time posting....I bought an 1864 last spring to use for snow removal and I had it rebuilt this past Fall. I put a new coil in it about a month ago as well. About a week ago I was blowing snow (with the side panels off) and after about an hour had an odd noise and I think a puff of smoke and then it started running like garbage. I got it back to the garage and shut it off. I thought it might be a fuel issue, so I checked and replaced the fuel pump (old pump wasn't putting out much fuel). Cleaned up the carb a few times and replaced some of the lines. It will crank over beautifully, but will not start. I haven't checked for spark yet (next check) but I was wondering if there is anything else I should be looking for. Electrical is not my strong suit and some snow definitely blew through the engine. When I turn the key, I get the low oil (it isn't) and the disengage PTO light on when cranking (pto is not spinning). Engine is the CH18s.
|