[MARK (LI)]

Originally Posted by CADplans

On my first Cub,, I had similar slop,,

It ended up being the through hole in Items 6 and 7 of the previous image.

I welded a 1/2" bore locking collar on Items 6 and 7,, at the top, and the bottom.
Then, I had to get bolts that were one inch longer (the collars were 1/2" thick)

The bolts were tightened, and the slop was gone,, forever,,,

I did find them at McmMaster...less than 2 dollars each for teh zinc coated steel...is that what you used ...or did you use stainless?...not sure what rods to use to weld if I were to use the stainless