Quote:
Originally Posted by riflemann
I back off the nut all the way to where it almost comes off the rod and still not enough pressure to engage. Clutch completely released and I can see there is still a small gap between plate and disc while it is larger gap at the bottom of the plate than the top. The rubber cradle snubbers are also off the engine cradle about 3/8" of an inch.
I just need more clutch release and get better alignment.
|
Question to you: Before you put the driveshaft/clutch assembly back in the tractor, was the clutch disk squeezed tightly between the pressure plates. It should have been. If after installation you now have a gap between the plates and disk with the the linkage disconnected then something is assembled wrong. Some pictures would help to determine what the problem is.