This project will take some time, as I need to buy stuff as it can be afforded. I want a creeper for sure, bar ag tires, and then all the usual consumables for example almost certainly a clutch disk and anything else that comes up. I will probably at least tear down, light overhaul the motor. Was considering having stuff sandblasted but just doing a small 1 cyl engine/trans last time cost $100 so having the frame, engine block, rear end housings, and all that would probably not be worth it and so I'll have to learn about paint stripper and power wire brush usage
. I'm sure the steering is loosey goosey and that wont do, so will have to go through that from end to end. I do have a lathe and (when I get it set up) Bridgeport which may help.
By the way, are there any
downsides to up-powering one of these with say the 14 or 16hp (K321 K341) that was mentioned?
Couple more questions, what years do the creepers fit, and what years on the PTO if I see one?
Thanks for the replies!
