169 3-point (338x450).jpg
Hmmm, not sure I did that right. If it shows up it's the 3-point I built for the old 169 15 years ago or more. Bolts on in-place of rear cover, no other bracing. Will pick up way more than the tractor should with the large lift cyl. The lift links were new this spring, finally wore out the old ones. Arms and top link bracket came from cub add-on that was just partially there at a surplus store. Lift cyl is a shortened cross slide cyl off of a fork lift in the local scrap yard. Circuit spliced into the attachment lift for the 169. Use a little clevis attached to the frame to lock the factory lift into one place when using the 3-point. Works pretty good (has down-pressure too), that's why was looking at just transplanting whole shooting match into the 1864.