Quote:
Originally Posted by GERKS 149
Been having trouble with my 1450. After running about 15 minutes, it dies and doesn’t want to start again until you let it sit for a few hours.
I have seen the exhaust valve do this, but I don’t have a spark when this happens. I replaced the coil and the condenser and no change. The plug is clean too. Anybody seen this before? I’m going to check to see if I have power at the coil and coming out of the coil next.
|
You have a plan, if no spark as I understand you to say, their lies your no-run problem.
Wiring or ignition switch/ plug are common places to check
no sparky, no runny
Also check for a ground condition where the points wire connects,and also where it exits the point cover as well as set timing by static method.
