When I put power steering on my 1450 I found that; The power steering system doesn’t need to be centered, the hand pump can spin I indefenatly if there is no cylinder hooked up to it. That being said the steering wheel will never have a “home” position.
You do however want to make sure you center the turning radius/mount the cylinder properly. So you can turn equally as sharp in both directions. When I did mine I just fully extended the cylinder and the turned my wheels all the way to the left. Marked where the cylinder should be mounted then check the other direction.
Good luck with the install. You’ll love it with the loader.
Edit: you may want to consider leaving the hydraulic lift in place it, comes in handy when additional weight is needed on the rear end
__________________
Tanner
|