First, go to the Technical Library Section, on page #5 and download the Quietline Wiring Diagram.
Once you do that, you will see the "light switch" is separate from the Ignition Switch.
Quote:
|
I installed the lights fairly close to how they would have came from the dealership. It will eventually get a full led upgrade, while keeping the stock look,
|
Quote:
|
I used 10 gauge wire for everything I added, so I wasn't worried about having any wires over heat if they were run at a higher demand).
|
I read that YOU want the OEM and "stock look", yet you grossly oversize the wire. Installing LED lighting will result in using LESS amperage. Thus the normal 16 Gauge wire size is/was more than enough.
Sounds like....you have not got your wiring correct, causing an excessive load. I would suggest again, download the Wiring Diagram, follow it. 10 Amp fuse is way more than enough for the Lighting System.
Running as is, with that wire size, will burn out the Charging System (Stator & V/R) thus causing more expense.
