[70Cub]

Anybody else had one that would not come out? I have sprayed it with PB blaster, checked to make sure that the set screw is out. The front hole is oblonged thanks to the weld on the sleeve breaking. So i cut that off and the back one also because I am going to have to ream the hole out and create new sleeves for the pin and make a new pin. I started to drill out the pin last night and am about 3/4 way through one side and it still won't budge. I have even restorted to using a sludge hammer, the back side of the pin is loose you can see a gap but the front has not gap. Any help or suggestions would be very welcomed!