Quote:
Originally Posted by J-Mech
I'd say you're doing something wrong.
Don't understand how you would tighten a nut with a pry bar anyway.
Seems expensive to buy all new spindle shafts, when a trip by a shop.... just about any shop..... to get someone with an impact gun to get the blades off would have been easy, and cheap. I would have done it for free!
|
Impact wrench would not take it off. Tried everything we could think of. Nut has been rusted on there for years. The reason I tightened it with a pry bar is because I didn't have another handle that the socket would fit on. Is it possible that someone replaced one of the deck springs with one that is too tight? One of the springs does not look original and has the same look at a grade 8 bolt. When put together it spins perfect. No wobble or bad bearings.