View Single Post
  #1  
Old 03-28-2018, 10:39 AM
Mr Bob's Avatar
Mr Bob Mr Bob is offline
Senior Member
 
Join Date: Aug 2012
Location: West Virginia
Posts: 544
Default K321 rod oil hole position

I started a new thread on this as my rebuild thread was getting pretty long. I received my new Ign. switch and it took care of the no voltage to coil at start up position. Had the engine all set to put in frame for 2 weeks. Installed engine and hooked up drive shaft and installed starter. Awoke this morning and was worrying about the rod oil hole position. I know it states that the hole must face the cam shaft. Just can't get it straight in my head. Any one have a picture of an after market 10 under rod installed showing the correct position of the oil hole in rod? I have searched and could not come up with any picture. I just know I am going to have to pull the engine and take a look. Thanks for all the help . Have a great day.
Bob
Reply With Quote