View Single Post
  #8  
Old 02-28-2018, 08:55 PM
Jeff in Pa's Avatar
Jeff in Pa Jeff in Pa is offline
Site Sponsor
 
Join Date: Feb 2012
Location: Zionsville, PA
Posts: 3,171
Default

If you want to go back to the factory set up, I can make the drive hub, a driveshaft and the rear coupler.

You mentioned play at the pump ( rear ). What size is the hole in the shaft? It was 1/4" from the factory and used a spirol pin.

Is the current pin wearing the shaft hole obround?

Jeff
Reply With Quote