That repair isn't too bad. You have to pull the motor out of the tractor. Remove the shouds, and remove the flywheel. to remove the flywheel, use a harmonic balance puller. tighten up the puller as tight as you can get it and whack the puller pretty hard with a hammer and the flywheel should just pop off. To remove the seal, just screw a drywall screw into it and pull it out with some pliers. It shouldn't take more than 1.5 hours to do the entire job.
AJ
__________________
1980 [COLOR="Red"][/COLOR]482- Stock
1981 [COLOR="Red"][/COLOR]582- Mag18, Sleeve Hitch, Spring assist
1979 [COLOR="Red"][/COLOR]682- Mag18, Sleeve Hitch, Spring Assist, #1 Tiller
1980 [COLOR="Red"][/COLOR]782- Mag18, Sleeve Hitch
1983 [COLOR="Red"][/COLOR]982- Stock, Fully Optioned
|