Hello everyone. I had just recently bought a Cub 129 off a guy locally for $80. It didn't run at the time and he stated that the pto clutch wouldn't disengage. Well the float needle in the carb was stuck. Freed that up and runs beautiful. Well I tore into the clutch and rebuilt it and reinstalled back onto the tractor. One thing to note is the bearing didn't sit flush on the shaft due to a snap ring so I removed the snap ring to make it sit flush. I tore the whole pto engagement lever out and reinstalled it. Now my issue is the linkage running from the rock-shaft to the engagement lever is about 2 inches too short. And I put everything back together how it came off.
I am so frustrated with this thing. I can't figure out what happened. So I figured the best place to ask for help is OCC. so I registered an account and here I am. Can anyone help or ran into this problem.
Still figuring out how to post images.