Busy last few weeks working on the 2182. Here is what I have done:
1. Completely rebuilt both hydraulic valves
2. Removed steering column, removed old grease, and installed new boot and grease. Installed brand new guides for tilt steering, new tilt spring, new steering column boot, and new tilt steering button
3. Installed brand new dash/instrument panel
4. Replaced the hydro pump cork gasket (Finally!)
5. Removed driveshaft and removed old grease, and installed new rubber boots and new fan blade
6. Installed new fan belt
7. Installed front bumper I bought
8. Cleaned all electrical connections and retaped wiring harness
9. Installed new power steering cylinder
10. Fresh hydraulic fluid and filter
I think that's it! Was a fun project.
|