Quote:
Originally Posted by twoton
I would also add that the rebuild may not have been adequate.. 
Sorry martyrant, no offence intended. |
None taken, if it has to be done again I'll end up doing it myself with my neighbor (who's been rebuilding diesel engines for 50+ years) to make sure it's done right rather than having someone else do it this time.
Just trying to figure out if I can avoid rebuilding it (again) since it seemed to start working a lot better after adjusting those needles other than quitting after an hour of use.
Going to drain the gas like I said in my last post and clean/inspect the carb, I'll check the governor again but it seemed to be sitting ok.