Something I have been known to do when trying to get as much of a bolt in a hole as possible, leave off all washers and screw it in by hand or using light wrench pressure. When it stops, notice the gap below the head. Cut off that much from the bolt. Then install the washers on the bolt--they should provide your clearance so nothing bottoms out. There will only be 1/8-1/4" clearance this way so check carefully--make sure the frame is already up tight against the rear, or you will have to allow for that gap also.
__________________
2072 w/60" Haban
982 with 3 pt and 60" Haban
1811 with ags and 50C
124 w/hydraulic lift
782 w/mounted sprayer
2284 w/54" mowing deck
|