Drill two holes through your basket pulley one on either side of the shaft about 3/4 of a inch out from the collar then you can put a harmonic balancer puller on it with two bolts with nuts and washers on the back. tighten the puller down till it starts to grab Then start to apply heat to the collar then give it a turn on the puller just keep getting it hotter till it starts to come. Don't horse it or you will bend it. They cost $78.
It also helps to put a rag in the cylinder and put the head back on so the motor wont spin when you tighten the puller
Those threads don't look too messed up. if you need to, flip the cutters upside down in a 3/4 pipe threading die and cut the threads on your nipple a little deeper.
__________________
"Good Dogs Never Live Long Enough!" Casey Angeletti
|