So finally got around to getting the 782 BEAST set up for snow removal.
had to fab up some new brackets for the Power angle blade. Since the 782 has larger tires, and a supersteer front axle the blade when angled was up almost an inch at the corners. and we wanted the R-Bucket to lift just a bit higher.
The blade lifts around 8" and the bucket at the cutting edge is 26" up so can dump a lot higher. so with 1000# lift on the 3pt and 14,5" travel between the R-bucket and the Angle blade I dont think I will have any trouble with Any amount of snow that we would get this year. Hope to have the hydraulic top link on before Snow hits. That should make the bucket have another few inches and make it flatten out at about top seat level.
Now I Just Need Snow....
