Well Vic, I went out and found my Precision joint book. It would seem that that yoke was made for that particular oddball cross. I think your going to have to buy a new yoke. You need a 1900 series in the Precision line. You need a #1923 yoke to fit the shaft. You can get it at O'Reilly's or I'm sure Napa. It will have two keyways in it. Just use the correct one for the key you need. The cross that fits it is a #861 or #839 depending on where you want the grease fitting. Let me know if that helps...
On another note, I found the parts needed to build new PTO shafts for the rear PTO equipment for the SGT's. As in for a rear tiller or mower. Cool.
