PB Blaster
I would start by spraying a good penetrating oil around the top of each day for a day or two. Spray it around the top where the spindle comes through the axle and try to work the spindle back and forth. when you get it moving more freely I would try to shoot a shot or two of grease into the zerk fitting, then push down on the spindle while twisting it back and forth. Be careful if you try to drive it out you will mushroom the top of the spindle and then it will be very difficult to remove without filing the burr of the top of it.
Good luck, just a little time and effort.
__________________
Gary
1974 1650 50A "budscub" Was my fathers
1969 125 42"
1978 1450 44A dual hydraulics
1984 782 50C dual hydraulics, waiting for vanguard
Z-force Cub cadet Zero turn
Sears '66 Suburban 10 Sears '66 Suburban 12
2 Breaking plows, 2 disc's, front blade, rear blade, Sickle bar mower, 2 decks 3pt harrow
74 "Green 100 "John" 
|