Quote:
Originally Posted by mortten
Do you mean I have the bolts tightened too much?
|
Yeah, unless the casting and plate are terrible rusty, it sounds like you have it a little tight.
Keep in mind, when you put it back together you don't necessarily need to tighten the set screws. You can just slip it on the bearing, reattach the lever, pull it back and see if the pulley turns. Just make sure it is all the way on the bearing. This just makes the process a little easier if you have to do it a couple of times.
Once you feel confident that everything is as it should be, then tighten the set screws down.
Good Luck