finally got around to borrowing a mic and a bore gauge, and got these measurements reading top to bottom 90deg. apart.
3.497 3.505
3.503 3.503
3.498 3.498
crank measured 1.497 everywhere I checked it.
Can I use a standard piston and crank or will this have to be bored? I'm not a machinist so some of the measurements may not be 100% but they're close. thanks.
__________________
147 w/mower deck, plow and rototiller owned for 22 years
149 new to me in 2010
2 more 149's with a a42a snowblower new to me in 2011
|