Morning fellas,
Thank yall so much for the replys! I am reasonably mechanically inclined, and have the drive to do it. I have read the manual, and the only tool i dont have is press or vise to press the spring down in the piston barrel to remove the spring retainer. We actually just moved so my garage is really clean at the moment, cluttered with some boxes, but clean. Ill have to get a set of calipers from work so i can accurately measure the slippers. After reading over the manual i think i can do this. Im going to look up some videos on the youtube to get a better grasp on the whole thing as well.
I know the seals and gaskets are avalible through CCS as they have a "rebuild kit" are the barrings avalible through them as well? i dont recall seeing them yesterday.
And when the manual says to clean parts, i assume that means use a sacrificial quart of hytran or fresh hydro fluid?
Thanks again guys! great help!
Matt
|