07-27-2016, 05:26 PM
|
 |
Senior Member
|
|
Join Date: Jan 2014
Location: North Carolina
Posts: 769
|
|
Quote:
Originally Posted by finsruskw
Would be more important to inspect the motor mount holes for stripped threads if you have an aluminum pan.
Make sure the threads are good and the hole is clean clear to the bottom. Then be sure, if you replace any bolts, NOT to get ones that are too long. And do not over tighten them upon reassembly.
Many folks have this problem and replace them with a cast iron pan.
I have done three of my QL's that way.
|
Will do thank you 
|