PTO tripping main fuse after a bit
2084 Super. I'm not good with a volt meter, but from what i have been reading on here I think I have a coil issue. The lawn mower (engine) will run all day with pto off, maybe a minute with it on. I removed the belt to rule any drag problems and it still blows the fuse in the same amount of time. It has been doing this enough over time that I replaced the 20amp fuse with a 20amp breaker so I could reset it, as it would blow once or twice a mow, but now...
As a side note the blades and the motor have been bogging down occasionally like it was in real think grass before spinning back up to normal. Deck is clean and greased and spins freely, so would that also point towards a pto issue?
Thank-you
|