Thank you!
Guys, thank you all for your quick replies. You'll see by my Q's that this is all new to me, so I really appreciate your suggestions.
-Sam Mac - thank you for the links to the diagram and the conversion unit. Is the field coil contained within the PTO unit (as shown on the conversion unit), and how do you check the existing field coil?
- Roland - while the reverse switch is clearly labeled on the diagram (#14), the only relay listed is #7 - is that the reverse relay? And how would I check each to determine if they are hanging up?
-Jebow - thank you for the chassis manual link-WOW!! Troubleshooting section extremely helpful. While it says air gap should be set to .017, our PTO seems to run all day - as long as no reverse. Still, will check it out.
-Bocephus - I don't think our 1210 has the hydrolever. The mowing deck is raised/lowered by pulling the lever on the right and clicking it into place.
- Riesedesperado - thank you. See Roland's note above.
Again, thank you all!
|