View Single Post
  #4  
Old 05-18-2016, 08:05 AM
sawdustdad's Avatar
sawdustdad sawdustdad is offline
Grand Member
 
Join Date: Dec 2012
Location: USA
Posts: 2,627
Default

Some progress. Got most of the engine disassembled but some of my tools are still at the other house, so I had to stop. I need to bring my flywheel puller, spring compressor, etc down here so I can finish this.

Here are some pics of the piston. Head gasket definitely was leaking-in fact the head bolts were all just snug, not tight at all. Haven't seen any other problems. Alum oil pan is fine, but will more than likely helicoil it as I've been doing with all the alum oil pans I find.

Piston is shot.

Did not see any markings on the piston other than this one notch. Is this a std size piston?
Attached Images
File Type: jpg 20160514_193117.jpg (18.1 KB, 319 views)
File Type: jpg 20160514_193047.jpg (11.9 KB, 319 views)
File Type: jpg 20160514_193035.jpg (14.6 KB, 318 views)
File Type: jpg 20160514_193027.jpg (13.5 KB, 319 views)
__________________
Reply With Quote