Thread a full size nut on the shaft, put a flat washer on a 3/8" bolt, then stick the 3/8" bolt down the middle of the shaft, turn the nut "off" just till it makes good contact with the washer.
Remove the lever on the side of the gear box and remove the "plug" from the bottom of the gear box, put your knees under the wheel and hit the 3/8" bolt head (hard) with a hammer.
If you don't take the lever and the plug out of the gear box you risk breaking the aluminum gear box. Not following my own instructions, I just broke one a few days ago
Be sure to push up hard on the wheel with your knees.
After you damage the threads, take the shaft out, clean it up well and send it to me, I'll put the threads back on for you, I can put splines back on too but it's harder and costs more than twice as much.
__________________
More IH Cub Cadet Parts RIGHT HERE
|