View Single Post
  #4  
Old 03-26-2016, 01:30 PM
Wallknight Wallknight is offline
Member
 
Join Date: Aug 2015
Location: PA
Posts: 33
Default

AHHHH! Ok- tunnel off- where the drive shaft from the engine connects to the hydro, it has come loose. Its free-spinning on the hydro side. There's about 1" of hydro shaft spline visible, but the connector- the metal that goes on the splines and then connects to the rubbery disk - that is spinning freely from the splines.
What's the fix? Did I just loose a set screw? [looks like there's an empty set screw hole]
Reply With Quote