Just came in from the garage, I got it broke loose. This morning before church I went out and took a box end wrench and cranked about 90 degrees of pressure on the rod and heated the pin up . I could not get the pin red but the washer beside it was. I did that two times and nothing moved, I figured I would have to cut it out. After church and lunch I went out to remove the clamp and there was no pressure on the wrench. It must have freed up as it cooled. I soaked it down with PB blaster and started cranking the rod with the wrench until it freed up. I ran it 3 or 4 cycles from the stop screw to the end of the threads until I could go all the way with out the wrench. I considered trying to remove the LH screw but decided to leave well enough alone. The rod is a little bent, It wobbles about 1/4 in when turned. I need to replace the wire cover on the harness above the pin. I melted a little of it. Thanks Sam, hold on to that pin someone will need it.
Cannon
|