Yeah mortten. I saved all the old ones I took off, just in case, and went back through them when I saw this. There may be one decent one in there. The bottom ones are all swollen and soft and the others are cut / crushed from being run long term with missing pan bolts. Even if i could use the old ones on the bottoms, they wouldn't last long.
Those CC Specialties mounts, they take the metal inserts? I have the inserts, so that's not a problem. I'm going to slap the sway bar mounts in for a try because they're reasonable and locally available. You think the CC mounts are softer? Does anyone know the durometer (softness) of them? And do they hold up? That may be the route I'll have to take. The ones i put in were a 40 durometer and I really liked the way they felt, they're just a bit too soft and can't hold up under the stress. I figure anywhere between 40 and 70 would be a good range. I've also done all the driveshaft work you have. Two rag joints on the hydro end...a single one left too much stretch...a single one on the front end. Didn't have to move any spirol pins that way.
__________________
--Ryk
|