Quote:
Originally Posted by Sam Mac
The adapter in the pic won't work on a 1772. That is for the pumps with the 5/8" round shaft, you need the one with the 5/8" nine spline like the one in this pic.
|
Well I hope Jeff see's this post?
This what I pm'ed him;
"I have received my drive shaft.
Are there any measurements I need to take, prior to you machining the adapters?
I need your PayPal address, so I can send you the money.
Just as a reminder 1864 CV drive shaft, in a 1772.
Thanks again."
His response;
"No measurements from you are needed. Sam Mac was kind enough to share the drawing and they've been working fine.
Thanks, I'll go start on it right now.
Jeff"
I will admit, looking back at the pictures of Cub123's install, I was thinking I would be getting (2) pieces from Jeff. But I figured you guy's had been down this road a few times, and knew better than I, what was required?