I bought a new dash for my 1572 over the summer and I finally got around to installing it. My old one was trashed beyond repair. I'm also fitting some aftermarket gauges while I'm there. I still haven't figured out how I'm going to install the temp probe for the temperature gauge. The D600 in the 1572 doesn't seem to have the same boss for the sensor as the pictures I seen of Sam Mac's gauge install on the 2182.
Here's how bad the old dash was. Duct tape and rivets were all that was holding it on.
Here is a mock up of the new dash with the gauges. I also decided to cut a piece of diamond plate that I plan to epoxy to the plate that the gauges mount too. It's a work in progress, but it should turn out good when I'm finished.
