[IH1650Cub]

I'm sure this has been talked about many times so I apologize in advance.

I have a couple of 1650's and three mowing decks for them. Two 44A's and one 44C. I am currently doing a total rebuild on the 44C deck with the matching mule drive. Besides the center pulley, front mule drive pulleys and moving the deck hangers to the outter holes on the deck what else needs to be changed in order for me to hang the C deck under my 1650?

Looking at the C mule drive next to the A drive there are considerable differences. the C drive seems beefier and the middle secition of the mule drive is curved where as the A's aren't. Can i change that middle section out with an A portion so the deck can hang with out belt interference?

I'm not sure if I have articulated myself well enough there. I'll post pictures if needed.

Thanks again! If there is a thread that already answers this can one tell me how to find it?

Scott