Quote:
Originally Posted by Bob95065
Where did you get the HD clutch arm?
This thread has been really helpful. I am getting ready to rebuild the clutch on my 1000 and I learned a lot here. Being more of a woodworker than a welder I appreciated the hardwood clutch spring compression tool.
Thanks!
|
Bob, I did not have to replace my release arm. It was in good condition, except for the bolt ovals, I mean holes which I fixed and as I used the blue spring, which is a good middle of the road spring I did not feel that I needed the heavier arm. But… I think you can find them here if you need.
http://midwestsupercub.net/MWSC2015.pdf
Item #10 on page 11. You might want to call them to find out which one would work for your application.