Quote:
Originally Posted by Md2pigeon
Troubleshot the problem a little more tonight with a power probe and was able to narrow it down to the ignition switch....i just replaced this two weeks ago before the pto went out. Looks like it is gone again i replaced it with the correct switch with the new replacement part number. Im not sure what would cause the mower to eat ignition switches. I looked for signs of wear on any wires and could not find anything. Im still not sure why the starter does not fully engage when i touch the power prob to the post that leads to the starter....any ideas?
Mike  |
If you are touching the "S" wire you only need a small gauged wire but if you are touching the Side of the Solenoid that goes to the Starter you need a Large Gauge wire or it wont carry the current needed to spin the starter fast enough to engage