I've been giving this one a little more thought. You will need to replace your existing 3 pin driver because the one you have does not have the pilot bushing as part of the driver, you will need one like what IH cub cadet parts sells. You can click on his link at the top of the page. Once you get that, slide it in place on the clutch then measure the space between the back of the driver and the engine adapter. Then it's a simple job to make a spacer that will hold the driver and bolt to the engine adapter. Here is a pic of the driver from Marks web site. I don't have a pic of the other side but I'm sure someone here does.
__________________
2264 with 54 GT deck
1641 AKA Black Jack with a 402-E Haban Sickle bar mower
JD317 dump truck
BX2670 with FEL
|